Na officiálních stránkách RME jsem našel přímo vlákno se tímto problémem zabývající, a tam se píše následovné:
https://forum.rme-audio.de/viewtopic.php?id=33492If you don‘t need Singxer’s full 6.5 W power into 32 Ohms (very likely!):
• Set Singxer to low gain / 0 dB (all 4 bottom switches to the outside of the chassis).
• Connect XLR.
• Set ADI-2 DAC to Auto Reference Level.
• Dial ADI-2 DAC’s Volume to 0 dBr.
Set listening volume with Singxer’s Volume dial.
Only if you need Singxer’s full power (probably not)
• Set Singxer’s 4 gain switches to high gain / 11 dB (to the inside of the chassis)
• Set ADI-2 DAC’s Volume to -6 dBr
If you want to use ADI-2 DAC for volume control, look here, “Case2”:
https://forum.rme-audio.de/viewtopic.ph ... 21#p161721CASE 2, digital volume control:
If you want to use ADI-2's digital volume control to set listening level, ADI-2 DAC / (Pro) has a clever option that increases the usable dynamic range by 18 / (20) dB: "Auto Reference Level":
• Switch ON ADI-2's "Auto Reference Level".
• Set ADI-2 DAC's (Pro's) volume control to -18 / (-20) dBr. (1)
• Set ext. amp's volume control (or passive attenuators) slightly above your normal listening level.
• Use ADI-2's volume control to set the final listening level.
Now ADI-2 automatically adapts the reference level for best fit to your loudness demands, while maximizing it's DAC's dynamic range.
SIDEMARK:
(1)
The volume figures change from dB to dBr when Auto Reference Level is “ON”.
The dBr relates to the highest Reference Level then.
There is some control range and digital headroom above, that is reserved for intersample peaks or weak digital signals.
With “Auto Reference Level “OFF” the dB-figures (without r) relate to the manually choosen reference level.
---------------------------------------------------------------------------------------------------------------------------------------
SINGXER SA-1 potřebuje právě vybudit na vstupech, jinak moc nehraje nahlas, teda na můj vkus aspoň. Zkusím si s tím doma ještě pohrát, jsem teď v práci. Ale mám dojem, že jsem zkoušel tu hlasitost nastavit právě na těch -6 dBr u high gain a bylo to slabé, nebo na hraně a volume na zesilovači jsem točil skoro na maximum. Ještě vyzkouším i verzi s low gain, myslím, že měl ten zesilovač ještě medovější zvuk.
S tím zesilovačem jde udělat i DC Offset modifikace, vytáhnutím jumperů proudové ochrany, ale moc se mi nechce otevírat plombu na zesilovači a dělat zásahy do střev. Tím automaticky padá záruka na zesilovač. Navíc nerad bych ty přístroje omylem odpálil. Ale prý to hraje ještě lépe, viz. video.
https://www.youtube.com/watch?v=32zVw8TONio